![]() ![]() Use properly sized regulators and gas lines.Identify and repair any leaks or restrictions.Step 7: Are there problems with the gas delivery system? Note: In addition to speed, both material chemistry and surface finish can impact dross levels as workpiece heats up, more dross may form on subsequent cuts. Top spatter: Cutting speed too fast, reduce cutting speed Low-speed dross: Cutting speed too slow (arc shoots ahead), increase cutting speed High-speed dross: Cutting speed too fast (arc lags behind), reduce cutting speed Note: As consumable parts wear, arc voltage settings need continual adjustment to maintain torch-to-work distance. If using arc voltage control, adjust voltage.Adjust torch-to-work distance to the correct setting.Step 5: Is the torch-to-work distance set at the proper height? ![]() Note: Check to see if material is bent or warped in extreme cases this limitation cannot be corrected.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |